![]() The standard aluminum Miter Slider is the best choice for these applications. Miter Slider SE bars are not recommended for stationary jigs that must be locked into position within a miter slot. all tormek jigs using the 12mm bar will work on the grizzly. The GlideLOCK adjustment will accommodate slots measuring 0.740" to 0.765" in actual width. Its a good saw and I had upgraded it with a link belt, PALS, Incra miter. Includes removable T-slot retaining clips for BOTH ends of the bar for superior stability of larger jigs.īars are compatible with all INCRA Build-It Panels, and will fit square-sided miter slots approximately 3/4" wide, 3/8" deep, and with or without a 15/16" wide T-slot at the bottom. INCRA MITER SLIDER INCRA Miter Slider replaces the cranky, inaccurate wooden runners that you've had to rely on for your shop built table saw jigs. The 18" bar has two pairs of adjustment points. Long-wearing Nylon GlideLOCK adjusting discs provide a precise fit in the miter slot of most table saws, router tables, and band saws, and the discs also give the bars a smooth, low-friction travel. They are drilled with two separate bolt patterns: a set of (4) #10-24 holes to match perfectly with the INCRA Build-It Panels and a second set of (3) 1/4-20 holes all evenly spaced along the length to accept knobs and other fasteners commonly used when building jigs and fixtures. All steel Miter Slider SE bars are more rigid than any wooden or plastic runners, and they're not susceptible to changes in humidity or temperature. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |